Burkert Type 6013 Manuel d'utilisateur télécharger pdf (Page 13)

Assembly

7. ASSEMBLY

7.1. Safety instructions

DANGER!

Danger of explosion!

The device is a closed system. It must not be removed.

The following safety instructions must be observed:

• The surface of the device may become electrostatically charged.

In potentially explosive areas the surface of the devices may be

cleaned with a damp or an anti-static cloth only.

• Only specified cables and lines may be used.

• The operator must ensure an adequate strain relief.

• Lines with an outer diameter of 6 mm - 13 mm can be used.

Observe the maximum thermal load of the installed cables and

lines.

•

The inserted seal must be adjusted to the diameter of the cable

/ line.

The rated cross-section of the cables / line cores must be at

least 0.75 mm² and must not exceed 2.5 mm².

• Screws for attaching the cover of the terminal box must be

tightened to a torque of 100 Ncm (± 5 %).

DANGER!

Risk of electric shock!

Acute risk of injury from hazardous body voltage! Risk of damaging

the device by short-circuit!

• Before reaching into the device or the equipment, switch off the

power supply and secure to prevent reactivation!

• Live terminals in the terminal box may cause an electric shock,

short-circuit or explosion. Switch off the power supply. Only then

open the terminal box.

• The connection lines of the electromagnets must be permanently

installed in such a way that they are adequately protected from

mechanical damage.

• Observe applicable accident prevention and safety regulations

for electrical equipment!

Risk of explosion due to overheating!

In the case of battery assembly observe the following data of the valves:

• Dimension of the valve body: 32 mm x 32 mm x 10 mm.

• Material of the valve body: Brass (MS), aluminium (AL), stainless

steel (VA) or plastic (PA 6 GV).

WARNING!

Danger – high pressure!

When reaching into the system, there is an acute risk of injury.

• Before dismounting pneumatic lines and valves, turn off the pres-

sure and vent the lines.

• During the installation, make certain the flow direction is correct.

• Observe applicable accident prevention and safety regulations

for pressurized devices.

english

PTB 00 ATEX 2129 X

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Commentaires sur ces manuels

Pas de commentaire

Burkert Type 6013 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour l'eau Burkert Type 6013