Burkert Type 8112 Manuel d'utilisateur télécharger pdf (Page 6)

4 Mounting

4.1 Mounting sequence

The numbers in brackets refer to the ﬁgures on the following

pages.

Fig. 1: Lock ﬁtting ARV-LS8112.1 - unpressurised

1 Lock ﬁtting

2 Terminal screws (3 pcs.)

1 Screw the lock ﬁtting (1) with a resistant seal ring into the

thread of your vessel and tighten the lock ﬁtting (1) on the

hexagon

2 Clean the connection tube of the sensor and the lock ﬁtting

carefully and remove grease, oil and dirt. Insert the sensor

into the lock ﬁtting. Slide the tube into the requested

position and hold it

3 Make sure that the sensor is in the correct position (height).

The height adjustment of the sensor determines also the

switching point

4 Tighten the terminal screws (2) with a torque of 4 ±1 Nm

(3 ±0.7 lbf ft)

The terminal screws (2) press lightly into the tube and ﬁx

the tube of the sensor in this position.

6 Lock ﬁtting ARV-LS8112.1 --unpressurised operation

Mounting

32053-EN-070220

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Pas de commentaire

Burkert Type 8112 Manuel d'utilisateur Page 6